Filter
Top Products
Chapter 4 Replacement Procedures
Installing the display assembly
The following describes the procedure for installing the display assembly. (See from Figure
4-8-8 to 4-8-10)
1. Inserting the pole of hinge to the hole of hinge assembly, set the display assembly
with hands on the base assembly.
2. Secure the hinges with the following screws secure the display mask with the
following screws and stick the mask seal on them.
‧ M2.55 FLAT BIND screw x4(Lock tight)
Figure 4-8-8 Securing the hinge screws
NOTE: Be sure to apply the locktight to the screws instructed in the figure above.
3. Connect the LCD harness to the connector on the mother board.
Satellite L640/L645, Satellite Pro L640/Pro L645 Maintenance Manual (960-Q08)
4-31