Filter
Top Products
User’s Manual 4-30
Operating Basics
Changing Ultra Slim Bay modules
Ultra Slim Bay is a single-drive bay that accommodates either of the
following modules.
■ Ultra Slim Bay DVD Super Multi (Double Layer) Drive Kit II
■ Ultra Slim Bay HDD Adaptor II
This section explains how to change modules in the Ultra Slim Bay. The
illustrations show replacement of the Ultra Slim Bay DVD Super Multi
(Double Layer) Drive Kit II with the Ultra Slim Bay HDD Adaptor II.
Removing a optical disc drive module
To remove the optical disc drive, follow the steps as described below:
1. Save your work.
2. Turn the computer's power off - ensure that the Power indicator is off.
3. Remove all cables and peripherals that are connected to the computer.
4. Close the display panel.
5. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 6, Power and Power-Up
Modes, if required).
6. Remove the Ultra Slim Bay lock screw from the Lock position.
7. Set the Ultra Slim Bay lock screw in the Unlock position.
8. Slide the Ultra Slim Bay latch to the unlock position.
9. Grasp the hook in the concave of the optical disc drive and slide it out.
Only use the Ultra Slim Bay modules that are provided with your
computer.
Do not use any Ultra Slim Bay DVD Super Multi drive or HDD Adaptor from
other models including PORTEGE M700/M710, otherwise the computer
might be damaged.
To avoid injury, do not put your hand into the Ultra Slim Bay slot.
Always make sure the display panel is closed in Laptop mode before
turning the computer upside down.
Wait for all disk indicators to go out before you turn over the computer and
do not lay the computer down gently. Shock can damage the HDD or other
components.
The optical disc drive and other Ultra Slim Bay modules can become hot
with use. Be careful when removing the module.