Filter
Top Products
4 Replacement Procedures 4.3 Speaker Cover and Keyboard
3. Remove two M2.5x2.6 black bind securing screw.
4. Remove the connector CN11 on main board and keyboard.
Figure 4-13 Removing the keyboard
Installing the Speaker Cover and Keyboard
Install the speaker cover and keyboard according to the following procedures and Figure 4-
12, 4-13.
1. Connect the keyboard cable to h the main board connector CN11 and route it
correctly.
2. Secure the keyboard with two M2.5x2.6 black bind screws.
3. Place the speaker cover in the correct position and secure the following 10 latches, in
that order:
- Six bottom latches
- Four front latches
4. Close the display and turn the computer over.
4-26
Satellite A100/A105 / TECRA A7
Maintenance Manual