Filter
Top Products
4 Replacement Procedures 4.18 Switch Cover and Switch Board
Figure 4-39 Removing the switch Board
Install the Switch Cover and Switch Board
Install the switch board according to the following procedures and Figures 4-38, 4-39.
1. Seat the switch board in the correct position.
2. Seat the switch cover in the correct position and secure the following 7 latches, in that
order:
- Two right latches
- One latch on the front and bottom sides
- Three left latches
3. Turn the top cover upside down.
4. Secure the switch board with two M2.5x4 black flat-head screws.
5. Connect the switch board flat cables to CN4000 on the switch board.
6. Secure the EMI tape and Mylar in the correct position.
4-62
Satellite A100/A105 / TECRA A7
Maintenance Manual