Filter
Top Products
4 Replacement Procedures 4.7 Display Assembly
4.7 Display Assembly
Removing the Display Assembly
CAUTION: Use care to avoid that the antenna cable is caught between the display
assembly and computer.
Remove the display assembly according to the following procedures and Figures 4-19, 4-20.
1. Turn the computer so the back is facing you and remove two M2.5x5 black flat-head
screws.
2. Restore the normal computer placement and open the display panel.
Figure 4-19 Removing the screws from the back of the computer
3. Disconnect the LCD/FL cable from CN3 on the system board.
4. Remove four M2.5x5 black flat-head screws securing the LCD module to the top
cover.
5. Remove the wireless antenna cables from the top cover.
6. Remove the display module.
4-34
Satellite A100/A105 / TECRA A7
Maintenance Manual