Toshiba Satellite M300/M300D/ L310/L310D Satellite Pro M300/M300D/ L310/L310D Laptop User Manual


 
User’s Manual 6-13
Power and Power-Up Modes
Installing the battery pack
To install a battery, follow the steps below.
1. Turn the computer's power off.
2. Disconnect all cables connected to the computer.
3. Insert the battery pack.
4. Ensure the battery pack lock is moved into its locked position.
Securing the battery pack
Starting the computer by password
If you have already registered a password, there are two ways to start the
computer:
Swipe your fingerprint on the sensor if you have already registered the
fingerprint with the Fingerprint utility and enabled Fingerprint Power-on
Security. If you would not like to swipe your finger or cannot authenticate
the fingerprint for some reasons, push the BACK SPACE key to skip the
fingerprint authentication screen. You can try to swipe the fingerprint up to
five times. If you failed fingerprint authentication more than five times, you
must enter the password manually to start the computer. Enter the
password manually.
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3, Getting Started. The
following message appears:
The battery pack is a lithium ion battery, which can explode if not
properly replaced, used, handled or disposed of. Dispose of the battery
as required by local ordinances or regulations. Use only batteries
recommended by TOSHIBA as replacements.
Do not touch the latch while holding the computer. Or you may get
injured by the dropped battery by unintentional release of the latch.
Battery
Pack
Lock
Battery pack
Password=