Filter
Top Products
36
WARNINGS:
• To avoid burns, allow the projector to cool for at least 60 minutes before
you replace the lamp.
• Do not drop the lamp module. The glass may shatter and cause injury.
• Do not touch the glass lamp screen. Fingerprints can obscure projection
sharpness.
• Be extremely careful when removing the lamp housing. In the unlikely
event that the lamp ruptures, small glass fragments may be generated.
The lamp module is designed to contain most of these fragments, but
use caution when removing it.
6 Carefully remove the lamp module. Note that the lens end of the mod-
ule has a tab that connects in a slot in the bottom of the lamp cavity. You
must pull upward with enough force to disconnect the tab from the slot.
Dispose of the lamp in an environmentally proper manner.
7 Install the new lamp module. Slide the new module straight down over
the tunnel/hood, align the tab with the slot, then press to connect.
8 Re-latch the pull tab while pressing down on the lamp module.
9 Re-plug in the lamp cable.
10 Replace the lamp door by aligning the connector on the back of the door
with the projector and replacing the two lamp door screws.
11 Plug in the power cable, then press the Power button to turn the projec-
tor back on. Reset the lamp hour timer by simultaneously holding down
the two Volume keys on the projector’s keypad for 10 seconds. At that
point the LED will turn green and you can power on the projector. You
can also navigate to the Settings>Service menu and select Lamp Reset
to reset the lamp timer.
disconnect lamp cable
tab on lamp module
slot on projector
reset lamp time in Service menu