Filter
Top Products
5. INSTALLATION PROCEDURE
5.3 Loading the Receipt Roll
5-6
SPAA-206-R1
1) Turn the printer power ON.
2) Press down the Cover Open Button to unhook the printer cover. (1)
3) Check for the correct orientation of the receipt roll, and put it into the paper holder.(2)
4) Pull the receipt until it extends past the paper outlet for about 5 cm (3), and then close the printer
cover by pressing it’s front center gently and make sure that the Cover Open Button snaps up.
CAUTION!
1. Use only TOSHIBA TEC specified paper. Use of non-specified paper may shorten the print
head life resulting in problems with print quality, cause a paper feed failure, or shorten the
cutter life.
2. Do not subject the thermal receipt roll to water, oil, or heat source as this will darken the
paper.
3. Load the receipt roll in the correct orientation. Failure to do this may cause a paper jam
error.
4. Care must be taken not to damage the print head and platen when the printer cover is
opened as this may cause a poor print or a printer failure.
5. Do not open the printer cover while the printer is printing.
6. Do not hold the receipt while the printer is printing. Doing so may cause a paper jam.
7. When closing the printer cover, do not press it down too hard.
8. Do not put anything on the printer cover or push the cover too strongly. Doing so may cause
a print failure.
1
2
3
Cover Open Button
Print Cover
Receipt Roll