Toshiba TDP-TW95 Projector User Manual


 
79
Maintenance
78
4
Select items from the menu on the left.
Settings
: Make settings for the Wireless/USB input menu.
Status Display: Verify the projector state.
Features: Shows the functions available with the Wireless/USB input
menus.
Top: Returns you to the top page.
TOSHIBA Projector Site
: The browser will display the home page at http://
multimedia.projector-toshiba.com/map.html, providing
projector information. The home page address is subject to
change without notice.
(The Toshiba’s web site can be browsed only when your
computer can access the Internet.)
Details on major items
Settings
When Browser authentication has been set to On, access to the setup page requires the input
of the password.
Wireless Utility
:The items displayed on the screen can be set. Entering individual items
and press the Execute button to update their setting. Note, however, that
security items such as “Remote controland “Browser authentication
cannot be set.
Slide Show: The items displayed on the screen can be set. Entering individual items
and press the Execute button to update their setting.
Email: The item displayed on the screen can be set. Entering individual items
and press the Execute button to update their setting.
Status display
Displays some states of the projector.
Projector: Displays the contents of status display in the menu.
Wireless/USB: Displays the contents of status display of the Wireless/USB input.
Maintenance: Describes an error if it occurs, for example, when the lamp has blown.
Note
Clicking the ? button opens a popup help window.
Setting up the projector using a Web browser
(Continued)
The product’s light source is a mercury lamp that lights at increased internal pressure. Be sure
to fully understand the following characteristics of the lamp and handle it with extreme care.
The lamp may burst with a loud noise due to impact or deterioration, or fail to light at
the expiration of its life.
•How long it takes before the lamp bursts or the life expires may vary greatly by lamp.
Some may burst shortly after first use.
Burst is likely to happen if the lamp is used after the replacement period has elapsed.
When the lamp bursts, the broken pieces of glass may get inside the product or be
released outside from the openings for ventilation.
When the lamp bursts, a slight amount of mercury gas enclosed in the lamp along with
glass dust may be released from the openings for ventilation.
Immediately replace the lamp when a sign appears on the screen.
When the replacement time approaches, a message will appear on the screen.
The risk of burst will increase if the lamp is continuously used without being replaced.
•Frequently check the used hours and prepare spares when the replacement time
approaches. (Refer to “Status display”.
p.44
)
When the lamp is broken
If glass components, including a lamp and a lens, should break, handle the broken
pieces with care to avoid injury and contact your dealer for repair service.
In the event of lamp burst, unplug the product from the wall outlet, leave and completely
ventilate the room. Then, thoroughly clean the area around the projector and discard
any edible items placed in that area.
When the lamp bursts, consult a doctor if glass dust or mercury gas gets into your eyes
or you breathe it.
About lamp
Maintenance