Filter
Top Products
02
Gigabit Smart Switch
The front panel of TL-SG2424 is shown as the following figure.
LEDs
10/100/1000Mbps RJ45 Port
SFP Port
Reset
Front Panel of TL-SG2424Figure 1-2
Reset
Press this button for five seconds or above to reset the software setting back to
factory default settings.
LEDs
LED Status Indication
Power
On The Switch is powered on
Off The Switch is powered off or power supply is abnormal
System
On The Switch is working abnormally
Flashing The Switch is working normally
Off The Switch is working abnormally
Link/Act
On
There is a device linked to the corresponding port but no
activity
Flashing The corresponding port is transmitting or receiving data
Off There is no device linked to the corresponding port
10
00Mbps
On A 1000Mbps device is connected to the corresponding port
Off
A 10/100Mbps device or no device is connected to the
corresponding port
10/100/1000Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or
1000Mbps. Each has a corresponding Link/Act LED and a 1000Mbps LED.
SFP Port
Designed to install the SFP module. TL-SG2216/TL-SG2424 Switch features 2/4 SFP
transceiver slots that are shared with the associated RJ45 ports. The associated
two ports are referred as a
“
Combo
”
port, which means they cannot be used
simulta
neously, otherwise only SFP port works.
Introduction