TP-Link TL-SL1226 Switch User Manual


 
01
Gigabit Uplink Unmanaged Switch


TL-SL1226/TL-SL1351 Gigabit Uplink Unmanaged Switch provides you with a high-
performance, low-cost, easy-to-use, seamless and standard upgrade to boost your
old network to 1000Mbps. Increase the speed of your network server and backbone
connections, making Gigabit connection to a server or uplinking a network necessarily.
The TP-LINK TL-SL1226/TL-SL1351 Gigabit Uplink Unmanaged Switch features a non-
blocking switching architecture that forwards and filters packets at full wire-speed for
maximum throughput. The switch supports MAC address auto-learning and auto-aging,
IEEE802.3x flow control for Full Duplex mode and backpressure for Half Duplex mode.
It is compatible with all 10Mbps, 100Mbps and 1000Mbps Ethernet devices because it is
standard-based.
The TL-SL1226/TL-SL1351 Gigabit Uplink Unmanaged Switch is plug-and-play and no
configuration is required. Auto MDI/MDIX cable detection on all ports eliminates the
need for crossover cable or Uplink port. Each port can be used as general port or
Uplink port, and any port can be simply plugged into a server, a hub, a router or a
switch, using the straight cable or crossover cable. Diagnostic LEDs which display link
status and activity allow you to quickly detect and correct problems on the network.

Complies with IEEE802.3, IEEE802.3u, IEEE802.3ab, IEEE802.3z (for TL-SL1351 only)
¾
standards
24/48 10/100Mbps Auto-Sense RJ45 ports supporting Auto-MDI/MDIX
¾
2/2 10/100/1000Mbps Auto-Sense RJ45 ports supporting Auto-MDI/MDIX
¾
1 SFP(Small Form Pluggable) module interface (For TL-SL1351 only)
¾
Supports Auto MDI / MDIX cable detection on all ports to eliminate the need for
¾
crossover cable or Uplink port
Non-blocking switching architecture that forwards and filters packets at full wire
¾
-speed for maximum throughput
Supports MAC address auto-learning and auto-aging
¾
Supports IEEE802.3x flow control for full-duplex mode and backpressure for half-
¾
duplex transfer mode
LED indicators for monitoring power, link, activity, speed
¾
Internal power supply
¾
Introduction