Filter
Top Products
16
Smart Switch
Please connect the Ethernet ports of the switch to the network devices by RJ45 cable
as the following figure shown.
RJ45 Port
RJ45 Cable
Connecting the RJ45 PortFigure 4-1
Connect the SFP port to a SFP module. For the switch, if an SFP transceiver (purchased
separately) is installed in a slot and has a valid link on the port, the associated RJ45
port will be disabled and cannot be used.
SFP Port
Connecting the LAN PortFigure 4-2
Note:
SFP module supports hot-plugging, plug the SFP module into the SFP port and the
switch can identify it automatically.
The SFP port
supports 100/1000Base-FX SFP module at full-duplex mode. When
using a SFP module, you need to log on to the GUI of the switch and configure
the corresponding Speed and Duplex mode on Switching
→
Port
→
Port Config
page. For 100M module, please select 100MFD while select 1000MFD for gigabit
module. By default, the Speed and Duplex mode of SFP mode is 1000MFD. For
TL-SL2210/TL-SL2452, the SFP port can only be used with a gigabit module.
Connection
SFP Module