Filter
Top Products
TL-WN620G 108M Wireless USB Adapter User Guide
Chapter 2: Installation Guide
2.1 Hardware Installation
1. Connect one end of the USB cable to the Adapter.
2. Connect the other end of the USB cable to the USB port on your computer. Because
the Adapter gets its power from the host, there is no external power supply. The LED
should light up when the Adapter is plugged in and the PC is on.
2.2 Software Installation
2.2.1 Overview
The Adapter’s Setup Wizard will guide you through the installation procedure for
Windows 98Se, Me, 2000, XP. The Setup Wizard will install the TP-LINK TL-WN620G
Wireless Utility and drivers.
When you install the hardware before the software, the system will prompt “Found New
Hardware Wizard”, click Cancel, and run the Setup Wizard program on the CD-ROM.
The Setup steps for Windows 98Se, Me, 2000 and are very similar. The following setup
steps are for Windows 2000.
2.2.2 Software Installation for Windows 2000
1. I Insert the Resource CD into your CD-ROM drive, click Start and choose Run. In
the field that appears, enter F:\XXX\Setup.exe (if “F” is the letter of your CD-ROM
drive; XXX is the setup program path, which is labeled on the Resource CD), figure
2-1 should then appear.
2. You can click Cancel to end the installation on the Preparing Setup screen, figure
2-1. Otherwise, the Setup Wizard will display a screen similar to that shown in figure
2-2 after a moment.
Figure 2-1 TP-LINK TL-WN620G – Install Shield Wizard
- 3 -