Filter
Top Products
Installing a Hard Drive
Your StoreJet
™
3.5 HDD Enclosure is capable of supporting an IDE, or a SATA Hard Disk
Drive. It is IMPORTANT! that you match and install the correct Hard Drive to the correct
enclosure.
Installing a Hard Drive
If you purchased a Transcend StoreJet
™
3.5 HDD Enclosure that does not have a Hard Disk Drive
already installed, please read this section, otherwise you can skip to the “Driver Installation” section. Your
Transcend StoreJet
™
3.5 HDD Enclosure is capable of supporting an IDE, or a SATA Hard Drive, it is
important that you match and install the correct hard drive to the correct enclosure. You can identify the
type of enclosure by its part number. Enclosures with the Transcend part number TS0GSJ35-S support
SATA Drives, while enclosures with the part number TS0GSJ35 support IDE Drives.
1. Open the StoreJet
™
3.5 by removing the two screws from either side of the top cover, as indicated in
the diagram.
Figure 2. Remove the screws from the top cover
2. Remove the cover revealing a control board adapter; this converts the IDE, or SATA interface
connector of the hard drive to a USB 2.0 B-Type interface. Slide out the control board.
Figure 3. Remove the top cover revealing the IDE/SATA adapter
Installing a Hard Drive
5