Filter
Top Products
4
SBFTF10xx-12x
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Installation -- Continued
Set the Dip Switches -- Continued
NOTE: Dip switch 4 (in the “SW” set) applies to fiber port 1 (F1).
4. Fiber Mode (Fiber Port 1)
Up (Full-Duplex) - The cable distances for fiber port
1 (F1) are constrained by the cable requirements (see
pages 1 and 2).
Down (Half-Duplex) - The cable distances for fiber
port 1 (F1) are constrained by the 512-Bit Rule (see
page 9).
NOTE: DIP switch 5 (in the “SW” set) applies to ALL twisted-pair copper ports
(TP1, TP2, TP3, TP4, TP5).
5. AutoCross
Up (Enable) - The media converter connects
automatically to either straight-through or crossover
twisted-pair copper cable.
Down (Disable) - Either straight-through or crossover
twisted-pair copper cable must be installed,
according to the site requirements
6. Not in use
Fiber Full-Duplex
Fiber Half-Duplex
DOWN
UP
4
AutoCross Enable
AutoCross Disable
UP
5
DOWN
techsupport@transition.com -- Click the “Transition Now” link for a live Web chat.
5
Installation -- Continued
Set the Dip Switches -- Continued
NOTE: Dip switches 1, 2, 3, and 4 (in the Config. Switches set) apply ONLY to
twisted-pair copper port 2 (TP2).
1. Twisted-Pair Auto-Negotiation
Up (Enabled) - The media converter “advertises”
ALL rate and mode capabilities to the network:
• 100Mb/s full-duplex • 100Mb/s half-duplex,
• 10Mb/s full-duplex • 10Mb/s half-duplex.
Down (Disabled) - The bridging media converter
does not “advertise” the rate and mode
capabilities to the network. Switch 2 and switch 3
are then used to set the twisted-pair rate and mode.
2. Twisted-Pair Rate
Up (100Base-TX) - Sets the twisted-pair rate to
100Base-TX.
Down (10Base-T) - Sets the twisted-pair rate to
10Base-T.
3. Twisted-Pair Mode
Up (Full-Duplex) - The twisted-pair cable
distances are constrained by the cable
requirements (see pages 1 and 2).
Down (Half-Duplex) - The twisted-pair cable
distances are constrained by the 512-Bit Rule (see
page 9).
4. Monitor for Twisted-Pair Port 2 (TP2)
Up (Off) - The twisted-pair port 2 (TP2) functions
as directed by switches 1, 2, and 3.
Down (On) - The twisted-pair port 2 (TP2)
functions as a “sniffer” port and transmits all
packets received from ports F1 and TP1.
Twisted-Pair Full-Duplex
Twisted-Pair Half-Duplex
UP
DOWN
3
Monitor on TP2 OFF
Monitor on TP2 ON
UP
DOWN
4
Twisted-Pair 100Base-TX
Twisted-Pair 10Base-T
UP
DOWN
2
UP
DOWN
1
Twisted-Pair Auto-Negotiation ON
Twisted-Pair Auto-Negotiation OF
F