Filter
Top Products
3-5
Connecting to a Power Source
3
Connecting to a Power Source
To connect a device to a power source:
1. Insert the power cable plug directly into the socket located at the back of the
device.
Figure 3-5. Power Sockets
2. Plug the other end of the cable into a grounded, 3-pin socket.
Note: For International use, you may need to change the AC line cord. You must
use a line cord set that has been approved for the socket type in your
country.
3. Check the front-panel LEDs as the device is powered on to be sure the Power
LED is lit. If not, check that the power cable is correctly plugged in.
4. If you have purchased a Redundant Power Unit, connect it to the switch and to
an AC power source now, following the instructions included with the package.
Connecting to the Console Port
The RJ-45 serial port on the switch’s front panel is used to connect to the switch for
out-of-band console configuration. The on-board configuration program can be
accessed from a terminal or a PC running a terminal emulation program. The pin
assignments used to connect to the serial port are provided in the following table.
Figure 3-6. Serial Port (RJ-45) Pin-Out
BPS
DCIN
100/115/ 220/230V
1.0/1.0/0.5/0.5A
50/6 0 HZ
12V 4 5A 45 A
.
( )
,
8
1
1
8