Filter
Top Products
LED Indicators
The TE100-P1U has two LED indicators on the top; the TE100-P1P's LEDs are on the end.
The Error LED is red. The Status indicator LED is green. The LED indicator modes are
described in the following table.
Status LED
(Green)
Error LED
(Red)
Status Description
Off Off No power.
On Off Normal operation - Idle.
Flashing Off Normal operation - transmitting or
receiving packets from the network.
On On Hardware error.
On Flashing (USB only) No printer connected to the USB port.
Flashing Flashing Firmware upgrade in progress.
Diagnostic Push Button
The button is recessed; a pin or paper clip can be used to press it. This button has 2 functions:
• Restore the factory default settings
• Print a test page containing all current settings.
To restore the factory default settings:
1. Turn the Print Server OFF.
2. Press and hold the diagnostic button. While pressing the button, switch the Print Server
ON.
3. If you continue pressing the button for 10 seconds, a diagnostic page will be printed,
showing the new (default) settings.
To generate a Diagnostic print out
1. Ensure that both the Print Server and the attached printer are ON.
2. Press the diagnostic button, and hold it in for 2 seconds.
3. The test page, containing the current settings, will be printed.
Note:
PostScript printers are unable to print this page. If you have a PostScript printer, the test
page will not be printed.
Page 5