Filter
Top Products
English
4
3. Operation
Note:
3.1 Push Button
Press
To switch between computers, you can use the front-panel push button
or the "Hot-Key" commands.
the push button to switch between computers.
Push Button. (TK-200 shown)
3.2 Hot-Key Commands
A keyboard hot-key command consists of three keystrokes:
Hot-Key command = ScrLk + ScrLk + Command key(s)
After pressing the ScrLk key, you have 2 seconds to press the ScrLk key again.
You then have another 2 seconds to press a command key. If you do not press
a key within 2 seconds, the switch will exit hot-key mode.
Below are the “Hot-Key” commands:
In Hot-Key mode, press the “Up-Arrow” to select the next port, “Down Arrow” to
select the previous port, and “S” key to set the KVM switch to Auto-Scan mode.
ScrLk ScrLk
Previous Channel
Next Channel
Auto Scan
+ + =
ScrLk
ScrLk
ScrLk
ScrLk
S
+
+
+
+
=
=