Filter
Top Products
5
Troubleshooting
Q1: How do I configure TCP/IP settings on my computer?
1. Go into the Control Panel and double-
click the Network Connections icon,
right-click the Local Area Connection
icon and then click Properties.
2. Click Internet Protocol (TCP/IP) and
then click Properties. Then click on
Use the following IP address, and
make sure you assign your network
adapter an IP address in the subnet of
192.168.223.x.
Q2:
A2:
Q3:
A3:
If my network's IP is different than the PoE Switch's range, what should I do?
You should still configure the PoE Switch first. After all the settings are
applied, go to the PoE Switch's configuration page, click on IP settings and change
the IP address of the PoE Switch to match your network's IP.
I typed http://192.168.223.100 in my Internet Browser's Address Bar, but an
error message says “The page cannot be displayed.” How can I get into the TPE-
80WS's web configuration page?
First, check your hardware settings again by following the instructions in
section 2. Second, make sure the POWER and LINK/ACT lights are lit. Third,
make sure the TCP/IP settings are configured properly (see Q1). Fourth, since
the PoE Switch’s default IP address is 192.168.223.100, make sure that no other
network devices are assigned an IP address of 192.168.223.100.