Filter
Top Products
11
¾ Network SSID:
The SSID differentiates one Wireless LAN group name from another;
so all access points and all devices attempting to connect to a specific
Wireless LAN group name must use the same SSID. A device will not
be permitted to join the BSS unless it can provide the unique SSID.
If the SSID parameter is “ANY”, it will detect the strongest signal of
the wireless station.
¾ Channel:
It shows radio channel numbers that used for Wireless LAN
networking.
The channel number can be set only under the Ad-Hoc operation
mode. In Ad-Hoc mode stations, each station must have the same
channel numbers and SSID.
In Infrastructure mode, the Wireless Cardbus Card will automatically
detect the channel number of the Access Point.
Security: the setting of the Network Encryption.
This function is used to protect wireless communication from
eavesdropping. A secondary function of encryption is to prevent
unauthorized access to a wireless network, and it can be achieved by
using the Encryption function.
¾ Encryption Mode:
There are two kinds of encryption mode, WEP encryption and WPA-
PSK. Click the Enable Encryption to activate the security of the
Cardbus Adapter.
WEP-Key: WEP (Wired Equivalent Privacy) relies on a secret key
that is shared between a mobile station and a base station (Access
Point).
12
WEP-Passphrase: the Passphrase in the dialog box helps
you to create a group of WEP key in the Key Setting.
¾ Authentication Mode:
Open System: with the same WEP key between the stations,
the stations don’t need to be authenticated, and this algorithm
was set to default.
Shared Key: with the same WEP key between the stations in
this Authentication algorithm, this type will use packets with
encryption by transferring a challenge text which will be
acknowledge by both side of the stations. In order to choose
which authentication algorithm will be used, you must know
which one the station supports this algorithm first.
It is recommended to select “Auto” if you are not familiar with
the setting.
¾ Default Key (Key 1 ~ Key 4):
You can type the key that you want to use from Key#1 to Key #4, and
the key that you type will be the encryption between the stations that
you connected with.
¾ Key Length, Key Format and WEP Key:
If you select 64bit in Hex format, you must type 10 values in the
following range (0~F, hexadecimal), or 64bit in ASCII format, you
must type 5 values in the following range (0~9, A~Z and a~z
Alphanumeric).
If you select 128bit in Hex format, you must type 26 values (0~F,
hexadecimal), or 128bit in ASCII format, you must type 13 values in
the following range (0~9, A~Z and a~z Alphanumeric).
If you select 256bit in Hex format, you must type 58 values (0~F,
hexadecimal), or 256bit in ASCII format, you must type 29 values in
the following range (0~9, A~Z and a~z Alphanumeric).