Filter
Top Products
FCC Radio / TV
Interference Notice
Note:This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion.This equipment generates, uses and can radiate radio frequency energy, and if
not installed and used in accordance with the instruction manual, may cause inter-
ference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference using
one or more of the following measures: reorient or relocate the receiving antenna;
increase the separation between the equipment and the receiver;connect the equip-
ment into an outlet on a circuit different from that which the receiver is connected;
consult the dealer or an experienced radio/television technician for help.The user
must use shielded cables and connectors with this product.Any changes or modifi-
cations to this product not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate the equipment.This device complies
with part 15 of the FCC rules.Operation is subject to the following 2 conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
3-YEAR LIMITED
WARRANTY
TRIPP LITE warrants its products to be free from defects in materials and workman-
ship for a period of three (3) years from the date of initial purchase. TRIPP LITE’s
obligation under this warranty is limited to repairing or replacing (at its sole option)
any such defective products. To obtain service under this warranty, you must obtain
a Returned Material Authorization (RMA) number from TRIPP LITE or an authorized
TRIPP LITE service center. Products must be returned to TRIPP LITE or an author-
ized TRIPP LITE service center with transportation charges prepaid and must be
accompanied by a brief description of the problem encountered and proof of date and
place of purchase. This warranty does not apply to equipment which has been dam-
aged by accident, negligence or misapplication or has been altered or modified in any
way.
EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or
exclusion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s)
may not apply to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR
DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES
ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POS-
SIBILITY OF SUCH DAMAGE. Specifically, TRIPP LITE is not liable for any costs,
such as lost profits or revenue, loss of equipment, loss of use of equipment, loss of
software, loss of data, costs of substitutes, claims by third parties, or otherwise.
TRIPP LITE has a policy of continuous improvement. Specifications are subject to
change without notice.
9
Troubleshooting
8
A power source
such as a power
panel or poorly
insulated device is
too close to the
KVM switch or its
cables
Move the device that is
creating the electromagnetic
interference, or move the KVM
switch and/or its cables.
Problem Cause Solution
Keyboard Not
Responding*
Keyboard needs
to be reset
Unplug the keyboard from the
Switch, then plug it back in.
Switch needs
to be reset
Turn off the PCs.Wait 5
seconds;then turn the PCs on.
Switch is in “
Auto
Scan”
Mode
Press the [Spacebar] to exit
“
Auto Scan”
mode.
Switched between
PCs during boot-up
procedure
Shut down the PC and reboot
without switching between PCs.
* Some notebook computers, notably the IBM
®
Thinkpad
®
and Toshiba
®
Tecra
®
, have trouble working with a switch when their mouse and
keyboard ports are used simultaneously.To avoid this problem, only
connect the mouse port or the keyboard port to the switch.If you
connect the mouse port, you will need to use the notebook’s
keyboard when the notebook is the active computer.These
switches are designed to work with PS/2 keyboards.Older XT
(84 key) and AT keyboards will not work.
Video
Problems
200312045 B030-002-R owners manual.qxd 1/6/2004 3:26 PM Page 8