Filter
Top Products
http://www.tyan.com
32
2.10- Installing the Power Supply
There are three power connectors on your Thunder n3600R.
The Thunder n3600R requires an EPS12V (24 pin + 8 pin +4 pin) power supply.
All the three power connectors must be installed in order to boot up the system.
Please be aware that ATX 2.x and ATXGES power supplies are not
compatible with the board and can damage the motherboard and/or CPU(s).
24
121
13
12 +3.3V 24 GND
11 +12V1 23 +5V
10 +12V1 22 +5V
9 +5VSB 21 +5V
8 PWR OK 20 RESVD
7 GND 19 GND
6 +5V 18 GND
5 GND 17 GND
4 +5V 16 PSON#
3 GND 15 GND
2 +3.3V 14 -12V
1 +3.3V 13 +3.3V
1
5
8
4
EPS 12V 8-pin (CPU Power)
4 GND 8 +12V2
3 GND 7 +12V2
2 GND 6 +12V2
1 GND 5 +12V2
3
2
1
4
4 +12V3
3 +12V3
2 GND
1 GND
Applying power to the board
1. Connect the EPS 12V 8-pin power connector.
2. Connect the EPS 12V 24-pin power connector.
3. Connect the EPS 12V 4-pin power connector.
4. Connect power cable to power supply and power outlet.
NOTE
YOU MUST unplug the power supply from the wall outlet before
plugging the power cables to motherboard connectors.