Filter
Top Products
Installation Manual P700WLS ioProx Receiver
DN1628-0806
9
Testing the Transmitters
Operating Instructions
The following instructions can be used for both
models (2 or 4 buttons)
1. On the key tag transmitter, press for one (1)
second the button you programmed earlier to
activate the receiver. A red indicator light will
flash for the duration of the transmission.
Note: Pressing and holding the button down only
transmits a short pulse.
2. Release and press the button again to send
another transmission.
3. If the light on the transmitter does not light up
when you press any of the buttons, replace the
battery.
Troubleshooting
Replacing the Transmitter Battery
Tools required:
Flat edge tool or screwdriver
Battery model CR2032
1. Before you start, make sure the case is laid flat on the table and upside down.
2. From the key ring corner, use a flat edge tool or screwdriver to carefully pry open the case.
3. Push the coin shaped battery out of its holder and replace it with a similar battery being careful to
place the positive (+) side on top.
DO NOT install the battery backwards. It will damage the device.
4. Close the case. You will hear a snap that indicates the case is closed.
5. Test the transmitter and observe the red flashing light at the front when pressing a button.