Filter
Top Products
Installation Manual P700WLS ioProx Receiver
DN1628-0806
1
System Overview
The P700WLS ioProx receiver unit is designed to interface with an access control panel card reader
port using the Wiegand protocol or the Kantech eXtended Secure Format (XSF). The ioProx receiver
can read from a distance of up to 45.72 m. (150 ft.) with a power dipole antenna or 30.48 m. (100 ft.)
with a standard antenna.
The ioProx transmitters come in two versions: with 2 or 4 buttons. And each can come with or without
an integrated ioProx key tag. The receiver unit receives the ID credentials from transmitters which
consist of a site code and ID number. For increased security, the ioProx transmitter uses incremental
packet transmission so that a different transmission code is created every time the button is pressed;
Transmitters with integrated ioProx key tag also permit access to users when both ioProx receivers
and card readers are installed in different areas of the same building.
The receiver jumpers can be configured to determine which button on the key tag transmitter will
activate the receiver. The same transmitter can be programmed to operate up to four different
receivers (one per button) located within close proximity to each other (and to operate more receivers
that are located farther apart.) The transmitter ID will only be sent to the access controller when a valid
button is pressed.
Inventory
The P700WLS ioProx receiver unit provides a reliable long-range wireless access control from a gate
or an overhead door. Each unit is packed with:
1 P-WLS-A1 whip antenna
4 enclosure fastening screws
Mounting hardware is not provided.