Filter
Top Products
7
NOTE: If you return and find that an alarm has occurred while you were away, it is possible that an intruder
may still be on the premises. Go to a neighbour's house, and call the local police to investigate.
The alarm memory is cleared each time the panel is armed so that any alarms showing are alarms
that occurred only during the last armed period.
If An Alarm Sounds
Fire Alarm
If your system has been installed with fire detectors and the alarm sounds in a pulsing mode, follow
your emergency evacuation plan immediately (see “Fire Escape Planning” on page 15).
Intrusion Alarm
If an intrusion alarm sounds, indicated by a continuous bell or siren, the alarm may be silenced by
entering your access code. If the alarm was unintentional, call local authorities immediately to avoid an
unnecessary response.
You can determine the source of the alarm by following the instructions in the “Disarming” section (see page
6). Once the source of the alarm has been corrected, the panel can be restored to its original Armed state.
Function Keys
Each keypad has five function keys, located to the right of the number pad, which allow easy single-button
activation of the most commonly used features.
If these keys have been enabled by your installer
, you can
execute their programmed function by pressing and holding the corresponding key for two seconds.
For information regarding the operation of the function keys, talk to your alarm installer.
Programming Security Codes
Programming codes from an LED Keypad:
The Master Code
To program the Master Code, enter [✱][5][current Master Code][40][new Master Code]. The Master
Code must be four digits unless otherwise indicated by your installer. Enter digits 0 through 9 only.
Press [#] to return to the Ready state.
Be sure to record your new Master Code on the “System Information” page in this booklet. NOTE: We
recommend that the factory default Master Code [1234] not be used.
Additional Codes
Up to 36 additional codes may be programmed. Codes 01-32 are regular access codes. Codes 33 and
34 are duress codes. Codes 41 and 42 are the partition 1 and partition 2 master codes, respectively.
To program a new code:
Enter [✱][5][Master code][code number][new access code]. The code number is a double-digit number
from 01-34 or 41-42.
Access codes must be four digits long. Enter digits 0 through 9 only.
To exit code programming, press [#].
If an access code already exists for the code number you have selected, it will be replaced by the new
code. Be sure to record your new code(s) on the “System Information” page in this book.
To erase a code:
Enter [✱][5][Master code][code number][✱]. To exit code programming, press [#].
The master code cannot be erased.
Continued on page 10...