Ultra electronic 300plus Printer User Manual


 
Quick Start Guide Ultra Electronics Card Systems
Page 38 MAGICARD Color Printer
1. Hinge down the Pull-down Card Tray. Hinge down the Front Cover and lift up the Top
Cover to the vertical position, and remove the Cassette. Switch ON the power supply.
2. Get the motor to turn the rollers by operating the Cover Microswitch in the hinged cover, by
hand. Allow the motors to achieve full operating speed before applying the Cleaning Card
to the rollers, otherwise the motors will stall and the rollers fail to turn.
3. Clean the Front Rubber Drive Roller every 1000 cards printed or if mis-registration occurs.
Open a fresh solvent impregnated Cleaning Card and clean the Front Rubber Drive Roller
by inserting the Cleaning Card from the front with the impregnated side faced down, with
the rollers turning so that the roller turns against the Cleaning Card as shown in Position A.
4. Clean the Printhead Roller, normally positioned beneath the Thermal Printhead, by
applying the Cleaning Card (with the impregnated side faced down) to the visible surfaces
of the Printhead Roller so that the roller turns against the Cleaning Card as shown in
Position D.
NOTE Discard the Cleaning Card when it has dried out. One or two cards should be
sufficient to carry out these instructions.
5. Clean the Rear Rubber Drive Roller by inserting the Cleaning Card with the impregnated
side faced down, from the rear with the rollers turning (ie, beneath the Card Preventer and
the Sticky Roller) so that the lower roller turns against the Cleaning Card as shown in
Position E.
6. Clean the Card Feed Rollers every 1000 cards printed or if problems occur with cards
feeding from the Cassette. Using the Cleaning Card clean the two Card Feed Rollers. One
is normally beneath the Card Cassette and the other is close to theSticky Roller. These
rollers are geared together and cannot be turned by operating the Cover Microswitch as
above. Turn one Card Feed Roller by hand whilst applying the Cleaning Card, with the
impregnated side faced down, to the other Card Feed Roller. Repeat the cleaning process
for the other Card Feed Roller as shown in Positions B and C.