Filter
Top Products
Ultra Electronics Card Systems Quick Start Guide
MAGICARD Sprinter Flip Page 31
Card Settings Tab
Duplex Mode must be selected if requiring to print both on the front and the back of the
card. It must be deselected if the doument is a single page.
Manual Flip Mode does not apply to the Sprinter Flip model. This mode is used when cards
are turned over manually and reinserted, after printing the top. Used only for non-Flip
models.
Print Back Side Only enables the user to flip the card and print on the back if magnetic
encoding is also required
Hand Fed Mode enables the operator to feed the card via the front and will prevent cards
from being fed from the hopper.
Magnetic Encoding Only Prevents the card from being printed
The Power value (default 50) allows the user to adjust the density of the YMC, resin black
and the Overcoat panel if required. On earlier models, leave set at 50. (The printer will enter
a Fault mode if Resin Power is changed from 50.)
Paul Hare
Card Settings Image
Overcoat Tab
On this page, you can select the options for specific areas of the card to be overcoated for
each side, or for windows to be left in the overcoat (up to five in each case). Overcoating is a
2.5 micron layer of transparent acrylic protection that is available with some types of dye film
(For example the "O" in "YMCKO" dye film). The default settings are for complete coverage
to the card margins. For MAGICARD 300 it is 0,36,947,631 and for MAGICARD 300 plus it is
0,0,985,641. The four numbers are the X and Y coordinates of the bottom left and top right
corners of each area.
The Overcoat check box can be used to turn overcoating on and off.
The Ultra Secure box can be used to disable the feature if a dongle is fitted.
Paul Hare
Overcoat Tab Image