Filter
Top Products
www.ultramagicard.com
AVALON and AVALON DUO Printer USER MANUAL
Page 12 of 31
Every 1000 Prints -
Cleaning the Printhead
Step 2.
Changing the cleaning roller
There is a cleaning cassette inside the printer which holds a cleaning roller (picture 1).
We recommend that this roller is replaced after every 1000 prints, or sooner if it looks
dirty.
You re-use the cassette, and you replace
the roller within it.
To replace the cleaning roller:
• Switch off your printer.
• Open the top cover. Locate the black cleaning cassette towards the
rear of the internal compartment.
• To remove the cleaning cassette, hold it between thumb and
forefinger by the tab on the top of the cassette (picture 2). Push down
lightly on it, and then lift it out.
• You now have the cassette and roller assembly out of the printer. This is a two roller
assembly. The bottom roller is permanent and the top (larger) roller is disposable
(picture 3).
• Remove the used roller from the cassette (picture 4).
• Take a new roller and remove the protective white cover from around the
roller.
• Insert the new roller into the cassette, ensuring that the roller is ‘sprung’ in
the cassette.
• Insert the cassette back into the printer ensuring it is seated correctly.
Step 3.
You should clean the printhead if any lines are seen on printed cards.
To clean the printhead:
• Use the special printhead cleaning pen from your Magicard printer cleaning kit. See
‘Cleaning Supplies’.
• Open the printer and draw the pen several times across the length of the printhead.
2
1
3
4