Filter
Top Products
8. To hang up, use the escape sequence (a one-second pause, +++, and another
one-second pause) to return to command mode. Then type the ATH
Command. Or you can turn off your Intele–Modem.
How to answer a call from a computer or TTY __________________
Follow the same procedure to answer both computer and TTY calls. Your Intele–Modem
will switch to either 300-baud ASCII code or 45-baud Baudot code, whichever is correct.
1. Turn your computer on.
2. Load your communications software. Follow your software instructions to
get into terminal mode.
3. Turn your Intele–Modem on. The ON, BDT, and LO lights on the front panel
will come on.
4. While the phone is ringing, type the ATA Command. Watch for the CD
(carrier detect) light to go on. If it goes on and you read CONNECT on your
monitor, your Intele–Modem is communicating in ASCII code.
If you read CONNECT TTY on your monitor when the SIGNAL light goes
on, your Intele–Modem has connected with a TTY, and is communicating in
Baudot code.
5. Once you establish a connection, you can go ahead with your conversation.
6. Hang up by typing the escape sequence (a one-second pause, +++, and
another one-second pause) to return to command mode and then use the
ATH Command to hang up. Or turn off your Intele–Modem.
How to change communication settings ________________________
To change communication settings during a call, such as changing from full-duplex to half-
duplex, type the escape sequence (one-second pause, +++, and another one-second pause)
to enter command mode and then type the commands you want to change. Use the ATO
Command to go back on-line.
Setting up Auto-Answer ______________________________________
Setting the S0 register to anything greater than 0 puts the modem into Auto-Answer
mode. However, in most situations you’ll be better off using the Intele–Menu command set
for Auto-Answer. See page 8 for details.
CALLING WITH HAYES COMMANDS • 15