Filter
Top Products
6
Rear Panel
The 3-pronged power plug is located at the rear panel of the
DYNA-SWITCH/24 as shown in the figure. The switch will work with AC in the
100-240V AC, 50-60Hz range.
The rear panel of the DYNA-SWITCH/24
Desktop Installation
Set the switch on a sufficiently large flat space with a power outlet nearby.
The surface should be clean, smooth, level and sturdy. Make sure there is
enough clearance around the Switch to allow air circulation and the
attachment of cables and the power cord.
Attaching Rubber Feet
1. Make sure mounting surface on the bottom of the Switch is grease and
dust free.
2. Remove adhesive backing from your Rubber Feet.
3. Apply the Rubber Feet to each corner on the bottom of the Switch. These
footpads can protect the Switch from shock and vibration.