Filter
Top Products
42
Setting Trunking Delay
Setting a delay for trunking systems helps to ensure that you do not miss replies while
scanning.
2:SCAN OPTION → 2:TRUNK → Select the bank → 4:DELAY
1:NONE
The delay is turned off.
2:1 SECOND
The delay time is 1 second.
3:2 SECONDS
The delay time is 2 seconds.
4:4 SECONDS
The delay time is 4 seconds.
5:INFINITE
When the scanner stops on a transmission, you must press RSM to resume
searching.
6: -2 SECONDS
The scanner only stops on transmissions for 2 seconds, then automatically
resumes. To hold on the transmission, press
▲/HOLD during the 2-second pause.
7: -5 SECONDS
The scanner only stops on transmissions for 5 seconds, then automatically
resumes. To hold on the transmission, press
▲/HOLD during the 5-second pause.
8: -10 SECONDS
The scanner only stops on transmissions for 10 seconds, then automatically
resumes. To hold on the transmission, press
▲/HOLD during the 10-second pause.
Using I-Call (Motorola and EDACS only)
I-Calls are direct unit-to-unit transmissions that are not heard by other users. Your BC796D
can monitor these transmissions in either the search mode or (if you have stored the unit
number as a talkgroup) in the scan mode.
When the scanner stops on an I-Call, the scanner displays the individual radio unit ID
instead of a talkgroup ID.
EDACS or Motorola Type 1 i nnnnn
Motorola Type 2 7 nnnnn
Note: • Each radio in a system has its own unique unit ID. Unit ID’s are not published for
systems, and since officers might not use the same radio every day, it is difficult
to predict who and what you will hear for a specific radio ID.
• Since a conversation consists of two or more radios, and each radio has its own
ID, if you hold on an I-Call, you will only hear one side of the conversation.
Turning I-Call On and Off for ID Search
2:SCAN OPTION → 2:TRUNK → Select the bank → 9:I-CALL
1:ON