Filter
Top Products
I
,--""
--f-.
Indicates the keypad is locked.
Priority Channel Indicator - P appears
when the scanner stops on a Priority Channel.
2. Press @ to start scanning all programmed channels
that are not locked out. (SCAN moves across the display
during scanning.)
3.ln SCAN Mode, press ~ to stop scanning. (HOLD
appears on the display.) After you stop the scanner,
press @ again to resume scanning.
4. Press ~u;mj to turn the display backlight ON for 15 seconds.
Press \J1HTagainto manuallyturnthe lightOFF.
5. Use
0 to enter the decimal point when programming a
frequency into a channel. Ifyou make an entry error,
press C!) twice to erase the entry, and start over again.
6. There are 7 Preprogrammed weather channels.
Press@ to find the active weather channel in
your area. WX appears on the display in Weather Mode.
7. Use @ to set the limits of a range of frequencies for
Search Mode. When Search is stopped, or in SCAN
HOLD Mode, use.. to go down in frequency.
8. While Scanning, press @ to enter the PRIORITY
SCAN Mode. (PR~ears on the display.) While -
Searching, press ~ (TURBO) to toggle between 100
steps and 300 steps per second. (When in TURBO
SEARCH Mode, SRCH flashes on the display.)
9. Press(DELAY)to turn ON or OFF the automatic 2-second
delay during scanning or searching for active
frequencies. (In Delay Mode, DLY appears on the
display.) In this mode, when the scanner monitors an
active frequency, searching or scanning will not resume
until transmission stops for 2 seconds.
10. Press and hold(LOCK). rl appears on the display and
you hear two beeps. This disables the keypad and
prevents any accidental (ey )ntries. To enable the
keypad, press and hold LOCK. rl disappears from the
display and you hear two beeps.
G.
H.
8
..--
,-
j