Uniden WNP1000 Network Card User Manual


 
15
Saving the Configuration
The configuration changes that you make are automatically
saved into the flash memory of the WNP1000 Wireless AP
within a few seconds after you click the Apply button.
However, the WNP1000 Wireless AP will continue to use the
previous configuration values until you restart the WNP1000
Wireless AP by clicking the Reboot button on the left manual
page.
Each time you make a change, the WNP100 Wireless AP will
remind you by displaying a page such as the one shown below:
16
Access Point Configuration
Through the following procedure, you can enable the wireless
operation of the WNP1000 Wireless AP to allow
communication between wireless clients and devices on your
wired network such as a DSL/Cable modem, printers, file
servers, and e-mail servers.
LAN Setup
Click LAN Setup on the left menu. The following page will
appear.