USRobotics Wireless 54Mbps ADSL Router Network Router User Manual


 
English
5
When you are finished configuring the basic connection settings, you should
have Internet access. Launch a Web browser and register your product at
www.usr.com/productreg
If the page loads, you are finished with the installation procedure. If the page
does not load, refer to the Troubleshooting section.
Note: See “Configuring the Wireless 54Mbps ADSL Router” in the
User Guide
on the Installation CD-ROM for more detailed configuration information.
Contact your ISP if you have any questions about your WAN type or your
connection information.
Congratulations. You have successfully completed the installation
procedure. Please register your Wireless 54Mbps ADSL Router at
www.usr.com/productreg/.
Troubleshooting
If you have any difficulties connecting to the Wireless 54Mbps ADSL Router,
check the following issues and see if they apply to your situation.
If you are attempting to create a wireless connection but cannot connect
to the Wireless 54Mbps ADSL Router, make sure each wireless card is set
to infrastructure mode. If the wireless cards are set to 802.11g ad-hoc
mode, you will not be able to connect to the Wireless 54Mbps ADSL
Router. When each wireless card is set to infrastructure mode, it should
automatically connect to the Access Point of the Wireless 54Mbps ADSL
Router. If the wireless cards do not automatically connect, rescan until
they detect the Wireless 54Mbps ADSL Router and connect.
If you create a wireless connection to the Wireless 54Mbps ADSL Router
but are experiencing poor link quality, check the positioning of the
Wireless 54Mbps ADSL Router. Long distances, multiple floors, or steel or
concrete walls can diminish the link quality. If possible, reposition the
Wireless 54Mbps ADSL Router to reduce the effect of any of these
obstacles.
If you have the Wireless 54Mbps ADSL Router properly connected and can
access the Internet but are experiencing difficulties connecting with
special applications (such as ICQ or Battle.net), you must assign specific
ports in order to bypass the firewall function. For more information about
how to configure this function, refer to the
User Guide
on the Installation
CD-ROM.