Filter
Top Products
5
Installation
4. Installation :
Plug two SATA cables(Red) into the SATA
ports on the motherboard. ( Figure 5-D )
(5-4)
( Figure 5-A )
( Figure 5-B )
(5-1) Please remove the side panels of the case to
gain access to the chassis. Once inside,
remove the 5.25" front panel where you wish
to place the card reader. ( Figure 5-A )
(5-2) Insert the UGT-955-BK into the 5.25" bay as
shown in the figure. ( Figure 5-B )
(5-3) Tighten the screws of both sides. ( Figure 5-C )
( Figure 5-C )
( Figure 5-D )
(SATA Cable)
S ATA
All in 1 Multifunction Internal Card Reader