Filter
Top Products
9
CAUTION:
•
If engine fails to start, leave ignition key turned off and disconnect the negative
(-) clamp first, then the positive (+) clamp. Try again later – the engine may be
flooded.
• Recharge jump-start system after each use.
WARNING:
• Always disconnect the engine or frame jumper clamp first; followed by the
battery jumper clamp
• Never allow red and black clamps to touch each other or another common
metal conductor; this could cause damage to the unit and/or create
sparking/explosion hazard
• There is a risk of explosive gases being released when batteries are charged
or discharged. Failure to follow instructions may cause property damage,
explosive hazard, and/or personal injury
• Always use protective eyewear when using this product: contact with battery
acid may cause blindness and/or severe burns
• Keep out of children’s reach
• ALWAYS store battery clamps on clamp tabs when not in use. Never touch
battery clamps together, this can cause dangerous sparks, power arcing
and/or explosion
FIRST AID:
• SKIN: If battery acid comes in contact with skin, rinse immediately with
water, then wash thoroughly with soap and water. If redness, pain, or
irritation occurs, seek immediate medical attention
• EYES: If battery acid comes in contact with eyes, flush eyes immediately for
a minimum of 15 minutes and SEEK IMMEDIATE MEDICAL ATTENTION
3. CHARGING/RECHARGING
For maximum battery life, we recommend the VECTOR
®
system be kept fully
charged at all times. If the battery is allowed to remain in a discharged state,
battery life will be shortened.
NOTE: Recharging battery after each use will prolong battery life; frequent
discharges between recharges will reduce battery life
IMPORTANT:
• MAKE SURE ALL SWITCHES ARE TURNED OFF DURING RECHARGING
• Charge unit for full 48 hours using AC method, prior to first use
• Recharge unit fully after each use
• Recharge unit once a month when not in use
VEC022 Manual_Final_073106.qxp 7/31/06 6:36 PM Page 9