Filter
Top Products
Using the Verifone 250 Receipt Printer with MPI 2002
Page 4 of 4
Installing The Ribbon Cartridge
Remove the Ribbon Cover from the Printer Unit by simultaneously pressing-in
and pulling-up on the grooved thumb button on the front panel of your printer.
(Below the printer nameplate.) Check to determine if a printer Ribbon Cartridge
is installed. If a Ribbon Cartridge is installed, skip to the section entitled
“Installing Power Pack.”
Place the Ribbon Cartridge face up into the ribbon cartridge assembly. The
Ribbon Cartridge is face-up if you can read the manufacturer’s logo on the top of
the cartridge and the ribbon advance spindle (a small, round, toothed wheel on
the top right of the cartridge) is visible. Ensure the ribbon itself is in front of the
ribbon cartridge assembly. Refer to the Verifone 250 Receipt Printer Manual for
more information.
Turn the ribbon advance spindle clockwise until the ribbon is firmly seated in front
of the ribbon cartridge assembly. Lastly, replace the Ribbon Cover and proceed
to the next section.
Installing Power Pack
We are now ready to install the Power Pack. Before proceeding, ensure that the
Power Switch is in the OFF position. (From the front of the Printer Unit, the
Power Switch will be pushed “back” so that the “0” is down and the “I” is up.) In
the diagram on the next page, the Power Switch is in the ON position.