Filter
Top Products
24
25
APPENDIX
Serial/Data Cable
A wire that connects two serial ports carrying data to one another.
Transmission Speed
The rate at which data is sent over a communications line, usually measured in kilobits (kbps).
USB Cable
A wire connecting USB port carrying a data.
USB Port
A connector on a computer to connect peripherals using USB (Universal Serial Bus) protocol.
SPECIFIC ABSORPTION RATES SAR
Maximum: SAR 0.70 W/kg CDMA835 Body
SAR 1.02 W/kg PCS CDMA 1900 Body
SAR 0.60 W/kg WCDMA850 Body
SAR 0.96 W/kg WCDMA1900 Body
SAR 0.51 W/kg GPRS850 Body
SAR 1.03 W/kg GPRS1900 Body
THIS MODEL PHONE MEETS THE GOVERNMENT’S REQUIREMENTS AND EUROPEAN UNION (EU)
STANDARDS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed
the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The guidelines are based on standards that
were developed by independent scientic organizations through periodic and thorough evaluation of
scientic studies. The standards include a substantial safety margin designed to assure the safety of all
persons, regardless of age and health. The exposure standard for wireless mobile phones employs a
unit of measurement known as the Specic Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6
W/kg* and EU standards is 2.0 W/10kg.
Tests for SAR are conducted with the phone transmitting at its highest certied power level in all tested
frequency bands. Although the SAR is determined at the highest certied power level, the actual SAR
level of the phone while operating can be well below the maximum value. This is because the phone is
designed to operate at multiple power levels so as to use only the power required to reach the network.
In general, the closer you are to a wireless base station antenna, the lower the power output. Before
a phone model is available for sale to the public, it must be tested and certied to the FCC that it does
not exceed the limit established by the government adopted requirement for safe exposure. The tests
are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC
for each model. The highest SAR value for this model phone when tested for use at the when worn on