Quick Installation
1 Connect video cable(s)
Make sure both the monitor and computer
are powered OFF.
Macintosh users: Models older than G3
require a ViewSonic Macintosh adapter.
Attach the adapter to the computer and plug
the video cable into the adapter.
To order a ViewSonic
®
Macintosh adapter,
contact ViewSonic. See Customer Support
in this user guide.
2 Connect power cord
Connect the power cord from the monitor to
a properly grounded AC outlet.
3 Power-ON monitor and computer
Power-ON the monitor, then power-ON the
computer. This sequence (monitor before
computer) is very important.
NOTE: At this point Windows users may
receive a message asking them to install the
P220f INF file.
4 Install Display Optimization files
(1) Insert the ViewSonic wizard CD-ROM
into your computer’s CD-ROM drive.
NOTE: if your computer does not have a
CD-ROM drive, see the Customer Support
section of this user guide.
(2) Wait for the CD-ROM to auto-start.
NOTE: if the CD-ROM does not
auto-start:
double-click on the CD-ROM icon in
Windows Explorer, then double-click on
viewsonic.exe
(3) Follow the on-screen instructions.
5 Windows users: Set the Timing
Mode (resolution and refresh rate)
Example: 1600 X 1200 @ 85 Hz.
For instructions on changing the resolution
and refresh rate, see the user guide for your
computer's graphics card.
Installation is complete. Enjoy your new
P220f monitor!
To be best prepared for any future customer
service needs:
Write the serial number (see back of the
monitor) in “For your Records” on page 2
of this guide.
Register the warranty of your monitor on the
Internet at:
www.viewsonic.com
Port for DB-15
video cable
Power Cord
from monitor
to AC outlet
Power Cord
from computer
to AC outlet
ViewSonic P220f 4
• Connect the video cable to the computer