Filter
Top Products
Operating the PC Screen
You can use the remote control as a simplified mouse or keyboard.
CAUTION:
Mistaken use of the mouse/keyboard control could damage your equipment.
• Only connect to a PC.
• Before connecting, read the manuals of the device you will connect.
• Do not unplug the connector cables while the computer is operating.
PS/2, ADB, Serial Mouse Control
1
Turn off the projector and PC power, and connect the projector’s CONTROL terminal to the computer via
the mouse cable.
2
If a USB cable is connected, disconnect it. If a USB cable is connected, the USB control function is given
priority, and mouse control from the CONTROL terminal will not function.
3
Turn on the projector power, then the computer.
The functions in the table below can be controlled. If you have difficulty with control, restart the computer
(either from the software or by pressing the restart button).
USB Mouse/Keyboard Control
1
Connect the projector’s USB terminal to the computer using a USB cable. The functions in the table below
can be controlled.
NOTES:
• It may not be possible to control notebook PCs, and other computers with built-in pointing devices (e.g.
track balls), using this remote control. In this case, before connecting go into BIOS (system setup) and
select external mouse, and disable the pointing devices. In addition, the mouse may not function if the
computer does not have the needed utility program. See your computer’s hardware manual for details.
• The USB control can be used with Windows 95 OSR 2.1 or higher. It may not be possible to use the
remote control, depending on the computer’s configurations and mouse drivers.
• The USB control can only be used for the functions listed above. You cannot do things like press two
buttons at once (for instance, pressing two buttons at the same time to move the mouse pointer
diagonally).
• This function is not available while the lamp is warming up (the POWER indicator flashes green), while
adjusting the volume and display, correcting for trapezoidal distortion, zooming in on the screen, using the
BLANK function, or displaying the menu screen.
Available Functions Remote Control Operation
Move Pointer
Use , , , button
Left click with mouse Press ENTER button
Right click with mouse Press RESET button
Available Functions Remote Control Operation
Move Pointer
Use , , , button
Left click with mouse Press ENTER button
Right click with mouse Press RESET button
Press keyboard’s HOME key Press HOME button
Press keyboard’s END key Press END button
Press keyboard’s PAGE UP key Press PAGE UP button
Press keyboard’s PAGE DOWN key Press PAGE DOWN button
Press keyboard’s ESC key Press ESC button
ViewSonic PJ650/PJ520 24