ViewSonic PJ256D Projector User Manual


 
12ViewSonic PJ256D
Warning Indicator
When the “TEMP” indicator turns red, it indicates the projector has
overheated. The projector will automatically shut itself down.
When the “LAMP” indicator flashes red (0.5 second intervals), it
indicates a problem with the lamp. Turn off the projector and
disconnect the power cord from the electrical outlet, then contact
your local dealer or our service center.
When the “LAMP” indicator flashes red (1 second intervals), it
indicates the fan failed. Stop using the projector and disconnect the
power cord from the electrical outlet, then contact your local dealer
or our service center.
Powering Off the Projector
1. Press the “Power/Standby” button to turn off the projector
lamp, you will see a message as below on the on-screen
display.
2. Press the “Power/Standby” button again to confirm.
Otherwise the message will disappear after 25 seconds.
3. The cooling fans continue to operate for about 120 seconds for
cooling cycle and the Power LED will flash orange. When the
light stops flashing, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait until
the projector has completed the cooling cycle and has entered
standby mode. Once in standby mode, simply press “Power/
Standby” button to restart the projector.
4. Disconnect the power cord from the electrical outlet and the
projector.
5. Do not turn on the projector immediately following a power
off procedure.