Filter
Top Products
ViewSonic DSM3210
11
ENGLISH
2. Connecting RF antenna and Cable TV
Make sure the power is OFF before installing your Digital Signage Multimedia.
1) AIR TV: Connect the Digital Signage Multimedia to TV antenna with 75-ohm
coaxial cable. Preset the air TV channels into memory with Auto Scan function
when using an antenna TV system. This air input jack both support TV and DTV
systems. Besides, the TV system (NTSC) and DTV system (ATSC) can be found
by the scanning of “AIR” in the Auto Scan function. See page 22.
2) Cable TV: Connect the Digital Signage Multimedia to the cable with CATV and
Digital cable. Preset the cable TV channels into memory with Auto Scan function
when using a cable TV system. The cable input jack both support CATV and
Digital cable systems. Besides, the CATV system (cable TV) and Digital cable
system (clear QAM) can be found by the scanning of “Cable” in the Auto Scan
function. See page 22.
Note: Users can select either Air or Cable TV cable to be connected to the TV/DTV
IN jack. To watch both of them, use an adapter to connect both Air and Cable
cables to the jack.
Installation
1 Remove the battery cover by pulling then lifting the knob on the cover.
2 Insert the batteries, corresponding to the (+) and (-) markings on the battery compartment.
3 Reattach the battery cover.
1. Insert Remote Control Batteries
Only use the specified AAA batteries.
Do not mix new and old batteries. This may result in cracking or leakage,
which may pose a risk of fire or lead to personal injury.
Insert batteries according to (+) and (-) markings. Inserting the batteries
incorrectly may result in cracking or leakage, which may pose a risk of fire or
lead to personal injury.
Dispose of the battery in accordance with local laws and regulations.
Keep the battery away from children and pets.
When the remote control will not to be used for an extended period, remove
the batteries.
•
•
•
•
•
•
CAUTION