Filter
Top Products
ViewSonic WPD-100 32
3. Start PBC pairing procedure at access point side (please refer to the
instruction given by your access point’s manufacturer), then click ‘PBC’
button in wireless configuration utility to start to establish wireless
connection by WPS. Please be patient (This may take a period to
complete). When you see ‘WPS status is connected successfully’ message,
means the connection between this wireless network card and access point
is successfully established by WPS, and the information about access point
you connected to will be displayed.
4. You can click ‘Detail’ button to see detailed information of connected
access point. If you wish to save this connection as a profile, you can click
‘Export Profile’ button, and this connection will be saved. You can find this
connection in ‘Profile’ tab in a later time.
5. Sometime WPS may fail because no WPS-enabled access point is found. If
it happens, you can click ‘PBC’ button few more times to try again.
6. When an access point is connected, you can click ‘Disconnect’ to
disconnect your wireless network card from a connected access point, or
select another WPS-enabled wireless access point, then click ‘Connect’ to
establish connection to selected access point, if there are more than one
WPS-enabled access point found. You can also click ‘Rotate’ button, and
next access point on the list will be selected to establish connection.
7. If you want to delete a found access point from the list, select it and click
‘Delete’ button.