Filter
Top Products
4 CD-ROM Box Enclosure Installation Guide
a. Attach the IDE 40-pin data cable from the end-panel to the 40-pin connector
on the back of the CD-ROM drive. To ensure pin-1 to pin-1 connection,
orient the cable so the colored stripe edge is closest to the power connector.
b. Attach the 4-pin power cable from the end-panel to the 4-pin connector on the
back of the CD-ROM drive. The connector is ‘D’ shaped to ensure proper
connection.
2. Place the CD-ROM drive in the bottom enclosure cover. The CD-ROM drive’s
front face panel should be flush with the front corners of the case (positioned in
front of the guide flanges.)
3. Align the CD-ROM drive’s mounting holes with the mounting holes on the drive
rails and secure with four screws (two on each side).
4. Slide the back-panel connector assembly back into the end groove guide.
5. Place the top cover over the drive assembly, making sure the end-panel assembly
slides into its end groove guide.
Installing Covers and Rubber Stands
Top Cover
Bottom
Cover
Drive
Mounting
Screws (x4)
CD-ROM
Drive
Rubber
Stands (x4)
End-Panel
Assembly
Top Cover
Mounting
Screws (x4)