Filter
Top Products
DLP Projector—User’s Manual
– 51 –
LED Error Messages
ERROR CODE MESSAGES
POWER LED
BLUE
LAMP LED
RED
TEMP LED
RED
Lamp Ready ON OFF OFF
Start Flashing OFF OFF
Cooling Flashing OFF OFF
Over Temperature OFF OFF ON
T1 error 3 blinks 1 blinks OFF
Thermal Break Sensor error 4 blinks OFF OFF
G794 error 4 blinks 4 blinks OFF
Lamp fail 5 blinks OFF OFF
Ballast temp over 5 blinks 1 blinks OFF
Ballast circuit short 5 blinks 2 blinks OFF
Lamp End of lamp life detected 5 blinks 3 blinks OFF
Lamp did not ignite 5 blinks 4 blinks OFF
Lamp extinguished during normal opera- 5 blinks 5 blinks OFF
Lamp extinguished during run-up phase 5 blinks 6 blinks OFF
Lamp voltage too low 5 blinks 7 blinks OFF
Ballast fail 5 blinks 8 blinks OFF
Ballast communication fail 5 blinks 10 blinks OFF
Ballast over temp 5 blinks 11 blinks OFF
Restrike lamp fail 1 5 blinks 12 blinks OFF
Restrike lamp fail 2 5 blinks 13 blinks OFF
Lamp fail 1 5 blinks 14 blinks OFF
Lamp fail 2 5 blinks 15 blinks OFF
Fan 1 error 6 blinks 1 blinks OFF
Fan 2 error 6 blinks 2 blinks OFF
Fan 3 error 6 blinks 3 blinks OFF
Fan 4 error 6 blinks 4 blinks OFF
Case Open 7 blinks OFF OFF
DMD error 8 blinks OFF OFF
Color wheel error 9 blinks OFF OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above
, please contact your service center.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.