Filter
Top Products
www.vivotek.com
T: 886-2-22404099
F: 886-2-22404097
15
Software configuration
Easy way with installer program
In order to configure NetworKams remotely, administrators should keep the serial numbers of the new
NetworKams for identification and initial passwords. After successfully mounting NetworKams in the
proper position, run the Installer program on the appropriate PC to locate the newly installed
NetworKams. NetworKams also support manual setup procedures to non-Windows based environments.
The manual procedure is described next.
After the POST is done, NetworKam will try to configure itself by detecting the network environment. If
there is DHCP service over the network, the Installer program will catch the given information and
display the serial number and given IP address for each NetworKam as following figure. If no DHCP
service is available, a previous IP address will be displayed instead. In that case, it may be 0.0.0.0 for a
brand new unit. When multiple units are mounted, there may be several entries shown in the window.
Administrators may click on each entry with "Assigned" field labeled "No" to install sequentially.