Filter
Top Products
VIVOTEK
User's Manual - 79
Custom Command
If Custom Camera (scanner) is selected as the PTZ driver, the Preset Position and PTZ Control
Panel on the main page will be disabled. You will need to congure command buttons to control the PTZ
scanner. Click Custom Command to open the Custom Command page to set the commands in the
Control Settings session. Please refer to your PTZ scanner user's manual to enter the commands in the
following elds. Click Save to enable the settings and click Close to exit the page.
► If you select DynaDome/
SmartDOME, Lilin PIH-7x00,
or Pelco D protocol as the PTZ
driver, the Control Settings
column will not be displayed.
►For all PTZ drivers, a total of
five additional command buttons
can be configured.
NOTE: