Vox AD15VT Computer Monitor User Manual


 
16
Using the VFS2 dual foot switch
f the optional VFS2 dual foot switch (sold separately*) is connected to the rear panel
FOOT SW jack, you can use it to switch programs or turn effect bypass on/off.
SWITCHING THE CHANNEL PROGRAM (SWITCH 1)
Each time you press the VFS2’s left switch (switch 1), you’ll alternate between CH1 and
CH2.
NOTE: Switch 1 has the same function as the channel select switch on the top panel. If
you press switch 1 in Preset mode or Manual mode, you’ll change over to Channel Select
mode. Also, pressing switch 1 during the process of storing a program (the CH1 or CH2
LED is blinking) will change the store-destination.
TURNING EFFECT BYPASS ON/OFF (SWITCH 2)
Hold down the top panel BYPASS switch and press the VFS2’s right switch (switch 2).
This assigns the function of switch 2 as “bypass on/off.” Now when you press switch 2,
effect bypass will alternately be turned on/off.
HINT: The amp will remember the switch 2 assignment. This setting is remembered even
if you switch modes or programs, or turn off the power.
SWITCHING TO MANUAL MODE (SWITCH 2)
Hold down the top panel MANUAL switch and press the VFS2’s right switch (switch 2).
This assigns the function of switch 2 as “Manual mode.” Now when you press switch 2,
the amp will switch to Manual mode.
HINT: The amp will remember the switch 2 assignment. This setting is remembered even
if you switch modes or programs, or turn off the power.
I
VFS2 left switch (switch 1): Switches channel programs
VFS2 right switch (switch 2): Switches bypass on/off, or turn
Manual mode on