Filter
Top Products
Scanning 2-9
Scanning with the WLS 9500 Hands Free Stand
When the scanner is placed in the Intellistand, the scan pattern selected in hand-held triggered mode continues (see Scan
Pattern on page 4-7).
To operate the scanner in the WLS 9500 Hands Free Stand:
1. Ensure the scanner is properly connected to the host (see the appropriate host chapter for information on host
connections).
2. Insert the scanner in Intellistand by placing the front of the scanner into the stand’s “cup.”
Figure 2-7. Inserting the Scanner in the WLS 9500 Hands Free Stand
3. Use the WLS 9500 Hands Free Stand’s adjustment knobs to adjust the height and angle of the scanner.
4. Present the bar code.
When the bar code is in view, the scanner emits a full scan line. After 3 minutes, the scanner
automatically switches to a reduced scan line. After 1 hour, the scanner automatically switches to
blink mode.
5. Upon successful decode, the scanner beeps and the LED turns green. For more information about beeper and
LED definitions, see Table 2-1 and Table 2-2.
Scanner Holder
Height Adjustment
Angle Adjustment
Cup