Filter
Top Products
3.1.2. SetUp Switch Bank 2
The bank of DIP switches located closest to the front panel are used to select the Prefix Code
character and set the parity.
3.1.2.1. Prefix Code (Sw1 - Sw7)
As mentioned previously, the Prefix Code informs the unit that the next character will be a
command. The Prefix code can be any ASCII character. However, since it is passed on to the
connected device, it is recommended to use a non-printable character. The factory default is
^V (Control V). Please refer to the following table when selecting a Prefix Code.
(US)
Factory Setting = ^V
3-3